FXR Division Motorwitch Handle Bars for Road Glide
FXR Division worked directly with one of the Industries Top Motor Builders to Design and Build a set of bars that would that give Him and You the Narrow Width (30.5” from end to end with a 12 Degree Wrist Angle which they have found the to be the closest to Natural Wrist Position) and Stance of a T Bar, allow for a Direct Mount to your Factory Riser WITHOUT any need for expensive Gauge and/or Handlebar Relocation Plates, give FULL visibility of your gauges and Media Center, and hold up to the rigors of his performance riding abilities as well as his Built 151 Leading Edge Performance Equipped Motor.
Like their Split MX, Split Angle, and G Series Bars… they manufacture these IN HOUSE out of 1.250 X .125 steel tubing, they make sure to debur ALL material inside and out prior to welding for the smoothest wire pulls, and like ALL of their FXR Division Bars, are Throttle By Wire READY!
Comes in Gloss Black Powder Coat.
12” Motorwitch Bars DO NOT Require extending cables and/or lines… Your Stock Cables work just fine!!! May work up to 14" on newer Road Glides
Bars pictured are 14” FXR Division Motorwitch Bars… while they have had customers able to install WITHOUT extending cables… it may not always be the case.
If you would like to extend your Clutch and ABS Brake Line… Parts RECOMMENDED are below.
CAN BUS HANDLEBAR CONTROL WIRE EXTENSIONS
(1) GUERRILA CABLES Plug N Play CAN bus Xtra Length 34” (42” for 16 inch bars)
(1) Universal Clutch Line Adapter
(1) 70” Goodridge Clutch Line (71” for 16 inch Bars)
(1) Straight Banjo Fitting for Hydraulic Clutch Master Cylinder
TOP ABS BRAKE HOSE
(1) Goodridge ABS Adapter Block
(1) 60” Goodridge Brake Hose (63” for 16 inch Bars)
(1) Straight Banjo Fitting For Brake Master Cylinder
** If your OEM Perch Clamp has a locating pin… it will be necessary to remove it before installation**
*** Don't forget to get a set of NEW Gooden-Tite FLT Handlebar Bushings to go with your bars!***
Orders for Bars WILL BE subject to a 20% Cancellation Fee if order is cancelled after 7 Days from the Date the Order was placed***
ALL FXR DIVISION PARTS ARE PROUDLY MADE AND MANUFACTURED IN THE USA.